If equipped remove window crank.
Removing door panel 02 town and countrry.
I have a 2006 chrysler town country van with power sliding doors.
Using the trim pad removing tool pry the trim panel retaining clips from the door inner panel.
Open the side door all the way and remove the door latch retaining bolts.
The tools needed to remove the door panel include a small flathead screwdriver a torx t 20 star bit screwdriver a flathead screwdriver or a plastic trim panel removal tool and needle nose pliers.
The right side power sliding door will not close completely.
Any ideas what needs to be.
The only tools you ll need are a 12 mm wrench to unhook the battery and then you ll need a phillips screwdriver and either a door panel clip tool or a putty knife.
Replace any bent damaged or missing push pins.
Town and country door panel removal dodge caravan door panel removal beeping dashboard dashboard instrument panel loss of power beeping issue.
To remove the oem door speaker you ll need a torx t 25 screwdriver.
Remove the plug and remove screw attaching door pull cup to inner door panel.
Here is the procedure to remove the drivers front door panel removal.
The power window motor screws are torx t 30.
Remove the two screws on the front and rear side of the front door trim panel.
Partially close the door and pull the latch assembly out of the side door inner panel.
Remove the weather shield if necessary.
Remove screws attaching trim panel to door from below map pocket.
When closing it stops approx 6 8 inches from the door jamb and must be closed manually.
Remove the appropriate side door trim panel.
Disconnect all electrical connectors leading to the latch assembly.
Remove switch bezel and disconnect power window memory switch.
2006 chrysler town country van.