Removing Piece Of Siding From House

Look under the siding piece you just located for a short flat notch.

Removing piece of siding from house.

Look for a horizontal seam between two courses of vinyl siding. How to remove small pieces of vinyl siding 1. Pull the zip tool out to disengage the. If it remains stuck double check to see if.

Pull the piece of vinyl siding downward to disengage it from the course below it. Pull out the. Go to the end of that row either near a corner. Working in one direction unzip.

Locate the vinyl siding piece above the piece you need to replace. However depending on how your siding is arranged they could be to the left or the right as well. Insert the siding removal tool where the panels overlap and pull down and out. Cut the nails at the bottom of the row above the boards you re replacing.

Usually the nails will be below the piece of siding you removed. Cutting the nails will let you remove rotted boards without damaging those your e saving. Slide the hook of the zip tool between the buttlock lip and toplock. Remove the nails on the lap board then use the claw of the hammer to split the board down the center image 1.

Once all the nails are removed from the adjoining board the damaged one should just pull out. Lift up the very top portion of the trim to expose the top edge of the vertical siding. Score down the damaged lap siding with a utility knife. Insert the tip of the zip tool into the notch.

Use a cat s paw or other small pry bar to pull the nails from the course you need to remove. If the siding is hard to remove try tapping it with the palm of your hand. Use a small hacksaw with a sharp blade. More importantly removing one piece of siding should expose the nails on another piece that would normally be covered.

If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in.