A properly flashed roof valley should have an ice and water shield installed with roofing felt being properly secured over the ice and water.
Repointing roof valley.
How to repair a crack in a wall.
Cut each side of the flashing at the lower end to conform with the corresponding edges of the roof using sheet metal cutters.
If the ice and water shield is missing then you will have to remove the shingles on both sides along the valley put ice and water shield in place and re shingle the roof.
Cut each side at the upper end of the valley to conform with the.
This video shows how to re point the lead valley on a tiled roof safely using fibre reinforced mortar.
Repointing is basically a waste of time money what you should do is take out all the cement and re bed the tiles if done properly should last at least ten yrs.
By admin 4 years ago 1 817 views.
Take measurements of your roof flashing most flashing is 14 inches wide but yours may vary.
Check the entire roof valley carefully to locate the source of these problems.
The only material that will seal your valley is a good quality cement if you want it to leak by all means use expanding foam.
Category general diy videos tags re point lead valley lead roof valley.