If your patio driveway or other concrete slab is falling apart and losing its appeal then you need to give it a facelift.
Resurfacing concrete porch and steps.
Add liquid a little bit at a time to a peanut butter consistency.
The concrete comes with its own bonding agent.
Pour the resurfacer in a small area on top of your concrete.
A stamped concrete porch with matching steps make a dynamic duo.
When repairing or resurfacing concrete steps make.
Using the same color and pattern for both unifies the look and creates a seamless transition to your front door.
Add a second coat as needed while the first coat is still wet to ensure that the concrete has a smooth finished.
Mix concrete resurfacer according to instructions on the bag.
Put the powder in the wheelbarrow or cement mixer.
Pour it on the walk.
This step will help the new concrete adhere to the old surface.
Use concrete with at least 3 000 psi and good adhesion.
Find out how to repair and resurface old concrete steps so they look as good as new.
Lift your bucket and pour all of the mixed resurfacer onto your concrete in a strip that s 1 foot 0 30 m wide by 6 8 feet 1 8 2 4 m long.
Concrete resurfacing using an overlay can make an old cracked and pitted concrete patio look like new again.
Very simple and inexpensive.
See more ideas for a stamped concrete porch.
This patio i repaired the small cracks lightly ground the surface applied the overlay with a hand trowel at about 1 16 inch thick then dragged a broom across the overlay to give it a broomed finished look.
Start at one end of your concrete slab and work your way toward the other end.
Properly clean the surface and make necessary repairs as described on the bag.
Fill the walkway joints with peel and stick foam weatherstripping and dampen the concrete if necessary.
Brush the surface with a masonry brush or concrete finishing brush.
Instructions for resurfacing a concrete patio wash the existing concrete surface with a power washer.
Section off work areas no larger than 144 square feet 13 4 square meters.
The resurfacer is workable for about 20 minutes so mix just half a bag of powder with 5 cups of water at a time.
You do not want to fill in your existing control joints so apply duct tape over them.
Unify your porch and steps with stamped concrete.
It s essential that control joints and expansion joints are maintained.